Montigo DHS - Manual (Page 15)

P/N XG0511 Page 15
Hotshot Gas Fireplace Insert
Operation
On/Off Switch
The On/ Off Switch is located on the top right-hand side of the Hot-
shot Fireplace. Once the pilot is lit, and the gas control knob is in the
'ON' position, pushing this switch will toggle the main burner on or off.
(See figure 14.)
Burner Adjustment
Hotshot inserts are equipped with an adjustable burner, allowing you
to increase or decrease the amount of flames and heat output. To
adjust the flames, locate the black knob marked 'Hi-Lo', on the right
side of the gas control valve (See Figure 13).
 To raise the flame height, turn the black knob (located behind the
lower trim) clockwise.
 To lower the flame height, turn counterclockwise.
Figure 13. 'Hi-Lo' Adjustment on the Hotshot inset's gas valve.
Fan Adjustment
Turn the fan On/Off Speed Control to ' On '. The Fan will turn on and
off automatically depending on the appliance's temperature. Adjust
the fans speed by turning clockwise or counterclockwise. (See figure
13.)
WARNING:
Avoid contact with hot fireplace glass while adjusting burner.
Fan On/Off
Speed Control
On/Off Switch
Figure 14. The Hotshot's On/Off switch and fan speed control.
Pilot Burner Adjustment
1. Locate Pilot Adjustment Screw, see figure 13.
2. Adjust pilot screw to provide properly sized flame as shown.
3. After installing or servicing, leak test with a soap solution with
main burner on. Coat pipe and tubing joints, gasket etc. with
soap solution. Bubbles indicate leaks. Tighten any areas
where the bubbles appear until the bubbling stops completely.
To High Limit Switch
Pilot Burner Adjustment