ONICON System-30 MODBUS BTU User Manual
Page 2
11451 Belcher Road South, Largo, FL 33773 • USA • Tel +1 (727) 447-6140 • Fax (727) 442-5699 • [email protected]
System-30 BTU Measurement System MODBUS RTU RS485 04/14 - 0583-1 / 18345
Page 2
SAFETY INFORMATION
This meter was calibrated at the factory before shipment.
To ensure correct use of the meter, please read this manual thoroughly.
Regarding This Manual:
•
This manual should be passed on to the end user.
•
Before use, read this manual thoroughly to comprehend its contents.
•
The contents of this manual may be changed without prior notice.
•
All rights reserved. No part of this manual may be reproduced in any form without
ONICON’s written permission.
•
ONICON makes no warranty of any kind with regard to this material, including, but
not limited to, implied warranties of merchantability and suitability for a particular
purpose.
•
All reasonable effort has been made to ensure the accuracy of the contents of this
manual. However, if any errors are found, please inform ONICON.
•
ONICON assumes no responsibilities for this product except as stated in the warranty.
•
If the customer or any third party is harmed by the use of this product, ONICON
assumes no responsibility for any such harm owing to any defects in the product which
were not predictable, or for any indirect damages.
Safety Precautions:
The following general safety precautions must be observed during all phases of
installation, operation, service, and repair of this product. Failure to comply with these
precautions or with specific WARNINGS given elsewhere in this manual violates safety
standards of design, manufacture, and intended use of the product. ONICON Incorporated
assumes no liability for the customer’s failure to comply with these requirements. If this
product is used in a manner not specified in this manual, the protection provided by this
product may be impaired.
The following symbols are used in this manual:
!
!
i
WARNING
Messages identified as “Warning” contain information regarding the personal safety of
individuals involved in the installation, operation or service of this product.
CAUTION
Messages identified as “Caution” contain information regarding potential damage to the
product or other ancillary products.
IMPORTANT NOTE
Messages identified as “Important Note” contain information critical to the proper operation
of the product.