Looping outputs, Looping output termination, 8/16 channel – OpenEye OE4 User Manual
Page 35
29060AB
23
LOOPING OUTPUTS
The 8/16 Channel HVR unit may have up to 16 Looping outputs. Depending on the destination of the outputs, each output may have
to be terminated. The outputs are located on the BNC Connector Cable. Attach the cable to the input for the BNC Connector Cable
highlighted below.
The video inputs are 75 Ώ BNC connectors. Make sure there is a video source connected to the input and then connect a cable to the
Channel Out on the BNC Connector Cable. The looping outs can be connected to video monitors or combined with adapters to
connect to VCR’s.
LOOPING OUTPUT TERMINATION
When terminating the outputs becomes necessary, the HVR unit has built in termination that allows you to select individual outputs to
terminate individually. It is not always necessary to terminate the output when using it. It is dependent on the device with which you
are connecting it to. As a rule, if the image appears distorted or virtually unviewable, it most likely needs to be terminated.
8/16 CHANNEL
Always leave the dipswitch set to the ON position when the Looping Outputs are not used.
ON
Not connected to a monitor (Normal)
OFF
Connected to a monitor (Looped)