OpenEye CM-816 - Manual (Page 47)

48
Alarm Application
The alarms menu is where alarm connections
are configured.
Alarm Switch
–
Designate when the alarm will
be active; Off, On, or By Schedule.
Alarm Type
–
Designate if the alarm is normally
open or normally closed.

NOH – NO stands for Normally
Open.

NC/L – NC stands for Normally
Closed.
Example: A door sticker consists of two contacts that are connected when
under normal conditions. This type of input would be a NC/L or normally closed
alarm. The alarm will trigger when the two contacts are no longer connected,
such as an abnormal condition when the door is opened.
Alarm Output – Choose high or low.
Trigger Action
–
Specify which actions the camera should take when motion is
detected.

Send Alarm Message by FTP / E-mail – Select to send an alarm message to
a configured FTP and/or e-mail address when motion is detected. When
sending to email, the alarm notification is text only. When sending to FRP, the
alarm notification will upload a text file to the FRP location.

Upload Images by FTP – Select to assign an FTP site and configure various
parameters as shown in the figure below. When motion is detected, event
images will be uploaded to the appointed FRP site.

Upload Image by E-mail
–
Select to assign an e-mail address and configure
various parameters as shown in the figure below. When motion is detected,
event images will be sent to the appropriate e-mail address.
Make sure SMTP or FTP configuration has been completed. See the Mail and
FTP sections for more information.

File Name
–
Enter a file name in the box, ex. Image.jpg
. The uploaded image’s
file name format can be set in this section. Select the one that meets your
requirements.
Consult the documentation to the sensor input device to determine which of these to
use.