7 input connections, 8 displaying an unknown signal with auto set, 10 automatic measurements – OWON HDS Series User Manual

Page 25: 9 automatic zero-returning of trigger horizontal, Position and trigger level position

Advertising
background image

OWON HDS Series Handheld DSO & DMM 6-Using the Scope

6.7 Input Connections

See figure 2.

Look at the bottom and the right of the Oscilloscope. The Oscilloscope has seven signal inputs:
two safety BNC jack inputs (CH1 and CH2) for scope measurements, three safety 4-mm banana
jack inputs for Multimeter R, V and A measurements, and two quadratic jack inputs for
Multimeter capacitance measurements.

Isolated input allows independent floating measurements between Multimeters and Scopes.

6.8 Displaying an Unknown Signal with Auto Set

The Auto-Set feature lets the Oscilloscope display and measure unknown signals automatically.
This function optimizes the position, range, time base, triggering and assures a stable display of
virtually any waveform. . This feature is especially useful for quickly checking several signals.

To enable the Auto-Set feature, do the following:

1.

Connect the test probe to the tested signals.

2. Press

the

AUTO SET key and the Oscilloscope is under the automatic measurement

condition. The tested signals appear on the screen.

6.9 Automatic Zero-returning of Trigger Horizontal

Position

and Trigger Level Position

When we adjust the trigger horizontal position and trigger level position to be maximal to make it
off the screen center remotely, then we perform the following steps to make trigger horizontal
position and trigger level position return to zero automatically.

1. Press OSC ◄ key and OSC ► key simultaneously, the trigger horizontal position

automatically returns to zero.

2. Press OSC key and OSC key simultaneously, the trigger level position automatically

returns to zero.

6.10 Automatic Measurements

The Oscilloscope offers 20 types of automatic scope measurements. Your can display two numeric
readings: measurement 1 and measurement 2. These readings are selectable independently, and
the measurements can be done on the input CH1 or input CH2 waveform.

To choose a frequency for CHI1, do the following:

1. Press

MENU key and the function menu appears on the right side of the screen.

17

Advertising
This manual is related to the following products: