OWON HDS Series - Manual (Page 60)

OWON HDS Series Handheld DSO & DMM 8-Advanced Function of Oscilloscope
6. Press and hold the OSC OPTION key till ▲/▼ CURSOR V2 appears on the screen. Now,
adjust the OSC ▲ or OSC ▼ and you can observe the dashed line V2 moving ▲ and ▼
while the measured voltage value of V2 relative to the zero position of CH1 is displayed on
the screen. Also, the absolute values of V1 and V2 can be shown on the screen.
Now, you can see a screen that looks like the following figure 50.
figure 50: Use the Cursor for a Voltage Measurement
To use the cursor for a time measurement on CH1, do the following:
1. Press the MENU key and the function menus are displayed at the right of the screen.
2. Press the MENU ▲ or MENU ▼ key to select Cursor measurement key. Two key labels
selectable are shown at the bottom of the screen.
3. Press the F1 key to the measurement type Time. Two vertical dashed lines T1 and T2
appear on the screen.
4. Press the F2 key and jump to the measured channel CH1.
5. Press and hold the OSC OPTION key till the ▲/▼ CURSOR T1 appears on the screen.
Then, adjust the OSC ▲ or OSC ▼ and you can observe the dashed line moving left and
right. At the same time, the time value of T1 relative to the screen middle point position
will be displayed on the screen.
6. Keep pressing on the OSC OPTION key till the ▲/▼ CURSOR T2 is displayed on the
screen. Then, adjust the OSC ▲ or OSC ▼ and you can find that the dashed line T2 is
moving right and left while the time value of T1 relative to the screen middle point
position appears on the screen. You can also observe the absolute time values and
frequencies of T1 and T2.
５２