REMKO CMF 320 Duo - Manual (Page 4)

REMKO CMF - DUO
Carefully read the operating
instruction before placing the
equipment in service. It provides
useful tips and information as
well as hazard warnings to prevent
injury or material damage
! .
Failure to follow the directions
in this manual can result in
endangerment to persons, the
environment and the equipment
itself and will void any claims for
liability.
■ Keep this manual and the
refrigerant data sheet near the
unit.
■ The unit should be set up
and installed only by qualified
personnel.
■ The set-up, connection, and
operation of the unit and
its components must be in
accordance with the operating
conditions stipulated in this
manual and comply with all
applicable local regulations.
■ Mobile units must be set up
securely on suitable surfaces and
in an upright position. Stationary
units must be permanently
installed for operation.
■ Modification of equipment
and components supplied by
REMKO is not permitted and
can cause malfunctions.
■ Equipment and components
may not be operated in areas
where there is an increased
risk of damage. Observe the
minimum clearances.
Safety notes
■ The electrical supply is to be
adapted to the requirements of
the equipment.
■
The operational safety of
equipment and components
is only assured if they are
fully assembled and used as
intended. Safety devices may
not be modified or bypassed.
■
Do not operate equipment
or components with obvious
defects or signs of damage.
■
All housing parts and openings
in the device, e.g. air inlets and
outlets, must be free of foreign
objects, fluids, or gases.
■
The equipment and components
must be kept an adequate
distance from flammable,
explosive, combustible, abrasive
and dirty areas or atmospheres.
■
Touching some parts of the
equipment can result in burns or
other injury.
■
Installation, repair and
maintenance work may be
carried out only by authorised
specialists. Visual inspections
and cleaning can be performed
by the operator as long as
power is disconnected from the
equipment.
■
To preclude any danger from
the equipment, take appropriate
hazard-prevention measures
when performing installation,
repair or maintenance work or
cleaning the equipment.
■
The equipment or components
are not to be exposed to any
mechanical stresses, extreme
levels of humidity or direct
sunlight.
■
If refrigerant has leaked from
the inside module, the room
must be properly ventilated
before re-starting the
equipment. Otherwise there is
danger of suffocation.
■
Burned-out fuses may be
replaced only by those of
identical construction.
■
The units must be inspected by
a service technician at least once
annually
■
In case of defects that endanger
the operational safety of the
unit, it must be taken out of
service.
■
Units may be mounted only
at the points provided for this
purpose at the factory.
■
The devices may be attached
only to load-bearing structures
or walls.
■
Regulations such as the regional
building codes and the Water
Ecology Act must be followed.
4