REMKO EFS 35 - Manual (Page 21)

7.6 Commissioning report
System operator
System location
Serial numbers
REMKO EFS25
- Medium flow rate probes
- Controller
- Software version
Primary piping Ø = mm l = m
Secondary piping Ø = mm l = m
Other installations q Circulation set q Return distribution set
q Miscellaneous:
Are both circuits cleaned and bled properly? (no air noises in the pump) q Bled
Are all shut-off valves in the cold water supply opened? q Opened
Is pressure of at least 1.5 bar present on the primary side? q Checked
Is pressure of at least 2.5 bar present on the secondary side? q Checked
Is an error message shown on the display? q No message
Installation operation Date, Signature
8 Maintenance
After each retroactive structural modification to the
primary side (e.g. installing a dirt separator, a dirt
trap or a mixing valve), you must start a new com-
missioning procedure in the controller to ensure
optimum regulation.
You should also carry out commissioning again
after adjusting the mixing valve temperature.
A specialist must check that the safety valve is
functioning correctly when commissioning and at
least once per year.
21