Sim2 Teatro 80 - Manual (Page 12)

11
ENGLISH
TEATRO 80 - M80
OUTPUTS FOR ACTIVATING MOTORIZED SCREENS
I 0
12 Volt
TRIG 1
TRIG 2
120 mA
The projector is equipped with two outputs (Voltage: 12
Vdc) for motorised projection screen and screen masking
systems, used for masking off the projection area to match
the projected image aspect ratio (Fig. 12).
The TRIG1 output is activated when the projector is switched
on (blue LED on) and is de-activated when the projector is
in standby mode (red LED on).
The TRIG2 output can be set with the Screen control adjust-
ment in the Aspect menu. This output allows reduction of
the area of a 16:9 screen, to a 4:3 format, by activating a
horizontal screen masking system output.
The HT5000 - PRO5DL projector is equipped with a 10/100
Mbit Ethernet interface by means of which the projector can
be connected to a LAN or to the Internet.
The network connection can be used to remotely control the
projector from any workstation with access to the network
by sending TCP/IP protocol commands.
Additionally, by suitably configuring the network specifica-
tions, you can receive e-mail notifications on the operating
status of the HT5000 - PRO5DL projector.
Configuring network functions by OSD (network
setup):
The “Network configuration” option in the “Setup” menu is
displayed only when no signal is being displayed (Fig. 14).
RS232 INTERFACE CONNECTOR OR USB INTERFACE
I 0
CONTROL USB
CONTROL RS232
You can control a projector from a PC by connecting to this
connector a cable from an RS232 serial port or to a USB port
of a PC (Fig. 13).
Fig. 12
Network Setting
IP Configuration
IP: 172.031.127.045 MAC: 00:00:00:00:00:00
Email Configuration
Fig. 13
11 NETWORK FUNCTIONS (RJ45 CONNECTORS)
This menu screen permits you to:
1. access the menu for setting the projector’s network
address
2. access the menu for entering the e-mail address for
receiving notifications on the projector status.
The projector’s current IP address and MAC address (physi-
cal address) are displayed at the bottom of the screen.
N.B. The system is delivered with default factory set-
tings, in which the dynamic IP address (DHCP) is ac-
tive. If the network to which the projector is connected
has no DHCP server, the current IP address displayed
on screen may not be valid.
Fig. 14
TEATRO 80 MB - EN.indd 11 25/10/10 18.02