Sim2 Teatro 80 - Manual (Page 9)

8
TEATRO 80 - M80
ATTENTION: Connect the units to a mains electrical
supply with rated voltage of between 110-240 VAC,
50/60 Hz and equipped with a protective earth con-
nection (Fig. 8).
I 0
Interruttore di rete:
Posizione I: acceso
Posizione 0: spento
Presa della rete
di alimentazione
Spina della rete
di alimentazione
In position I, the projector runs a number of initialization steps
(red and blue lights on), and then it goes into standby status
(red light on) (Fig. 9).
I 0
START UP FROM STANDBY
From the remote control:
press one of the keys 1...9 or 0.
From the keypad:
press the on/off key
I 0
0
When starting from standby, the lamp comes on. After a
short warm-up, the image appears (blue light on). The pro-
jected image comes from the input selected at the time of
the last shutdown (Fig. 10).
If too little time has elapsed since the last shutdown, the
lamp may not light if it is too hot.
In this case, you should let the lamp cool off for a few
minutes.
SHUTDOWN AND RETURN TO STANDBY STATUS
From the remote control: press the key .
From the keypad: press the ON/OFF key
Upon shutdown, the projector reverts to standby status, and
memorizes the input selected at the time of shutdown.
The fans continue to run until the lamp is cool (red and blue
lights on). Then they shut off automatically. Do not turn off
the projector with the network switch until the fans stop
running.
Fig. 9
Fig.10
Initialisation
Status Led blue Led rosso
Standby
On
Cooling
: Off : On : Flashing
Error (*)
(*):
If an error is indicated, contact SIM2 Multimedia
technical service.
8 START UP AND SHUT DOWN
Fig. 8
9 LED INFORMATION TABLE
TEATRO 80 MB - EN.indd 8 25/10/10 18.02