Space Ray RSTP Series User Manual
Page 12
Form 43206000
Sept 2011
-11-
2.
Install the suspension chains (according to Section 7.0) using proper suspension method (see Section 9.0).
chains for suspension
109-1/2
Hooks rated
@ 115lbs min.
Turnbuckle rated
@ 230lbs min.
Chain rated
@ 230lbs min.
109-1/2
Suspension
Chain
32
32
Chain rated
@ 115lbs min.
Hooks rated
@ 115lbs min.
Trapeze Method
Trapeze Method
Trapeze Method
Trapeze Method
Individual Suspension Method
Individual Suspension Method
Individual Suspension Method
Individual Suspension Method
3.
Lift the heater and suspend it into place. When lifting, caution should be used to avoid damaging the
assembly. Make sure that the long axis of heater is level.
Level indicator
The long axis of heater
Side View
4.
If the heater is to be used Indoors and Vented
Indoors and Vented
Indoors and Vented
Indoors and Vented to the outside, install the flue collar supplied with the heater
by placing the collar directly over the gasket. Secure the collar flange with clamps. See Figure 4 on next
page.
5.
Attach a 6” diameter flue pipe to the flue collar. Place an approved vent cap to the outside end of the flue
pipe. See Section 14.0) for flue vent requirements.
6.
If the heater is to be used Indo
Indo
Indo
Indoors and Unvented
ors and Unvented
ors and Unvented
ors and Unvented, order the Indoor Unvented Kit (Part #42406000). Remove
the clamps and install the Exhaust Hood directly over the gasket. See Figure 5 on next page.
7.
If the heater is to be used Outdoors
Outdoors
Outdoors
Outdoors, order the Outdoor Kit (Part #42411000). Install the Exhaust Hood as
instructed above in #4. Remove the solid cover panel from the side and install the Inlet Air Hood. Remove
the perforated cover panel from the top and replace it with the solid cover panel. See Figure 5 on next page.
After completing the assembly, silicone sealant should be utilized to seal the access panel openings. If the
installation site is subject to excessive wind conditions, it might be necessary to utilize pop rivets to secure
the reflectors to the heater body.