Super Systems HP2000 With 9100 Controller - Manual (Page 7)

This screen will display the temperature mode and it will also allow the user to change the
temperature mode. The temperature mode can be either Fahrenheit or Celsius. Pressing the up
arrow key will toggle between Fahrenheit and Celsius. Note: The user does not need to press the
ENT button; the change in temperature mode will take effect immediately. The change in
temperature mode does not convert the temperature set point or the alarm set point. These
factors will need to be converted manually once the change has been made. Pressing the CLR
button will return the user to the first screen. Pressing the NEXT key will display the next
screen, IP Address. Pressing the PREV key will display the previous screen, Alarm Set Point.
Screen 6: IP Address
This screen will display the IP address and it will also allow the user to modify the IP address.
Press the ENT key to begin changing the IP address. Once the user has pressed the ENT key,
the rightmost digit of the first three digits of the address will begin to blink. Note: Pressing the
ENT key will highlight the rightmost most digit of each section of the IP address. Pressing the
CLR key will reset the number to zero. Holding down the CLR key will display the first screen
to the user without saving any changes. Example – The following example will show how to set
the IP address of the HP2000 to: 192.168.1.210. Press the ENT key. The rightmost digit of the
first three digits should be blinking. Press the CLR key to reset the number to zero. Press the up
arrow key once, so that a 1 is displayed. Press the left arrow key once. Now a 10 should be
displayed. Press the up arrow key nine times so that a 19 is displayed. Press the left arrow key
once so that a 190 is displayed. Press the up arrow key twice so that a 192 is displayed. Press
the ENT key so that the rightmost digit of the next set of three digits is blinking. Repeat these
steps to enter the rest of the IP address. Once the last section of the IP address has been entered.
Press the ENT key to save the changes. Note: None of the digits should be blinking at this point.
Pressing the NEXT key will display the next screen, Output 1 Exponent. Pressing the PREV
key will display the previous screen, Temperature Mode.
Screen 7: Output 1 Exponent