Super Systems HP2000 With 9100 Controller - Manual (Page 8)

The Output 1 Exponent provides greater detail for the output. The valid range of values is zero
to ten. To change the value, press the up arrow key once so that the number begins blinking.
Pressing the up arrow again will increment the value. Once the desired value has been entered,
press the ENT key to set the value. If a value over ten is entered, the value will revert to the
previous value set. Pressing the NEXT key will display the next screen, Output 2 Exponent.
Pressing the PREV key will display the previous screen, IP Address.
Screen 8: Output 2 Exponent
The Output 2 Exponent provides greater detail for the output. The valid range of values is zero
to ten. To change the value, press the up arrow key once so that the number begins blinking.
Pressing the up arrow again will increment the value. Once the desired value has been entered,
press the ENT key to set the value. If a value over ten is entered, the value will revert to the
previous value set. Pressing the NEXT key will display the next screen, Output 1 Full Scale.
Pressing the PREV key will display the previous screen, Output 1 Exponent.
Screen 9: Output 1 Full Scale
The valid range of values for output 1 full scale is zero to nine thousand nine hundred ninety
nine. To change the value, press the up arrow key once so that the rightmost number begins to
blink. Pressing the up arrow again will increment the value. Pressing the NEXT key will
display the next screen, Output 2 Full Scale. Pressing the PREV key will display the previous
screen, Output 2 Exponent.
Screen 10: Output 2 Full Scale