Super Systems PGA3500 - Manual (Page 16)

SSi Manual 4559 Page 16 of 26 3-Gas Analyzer PGA3500
Revision Level - D
Pressing the circular arrow button will
display the following five variables:
PB%C – Percent Carbon as computed by
the probe
PBTC – Probe Thermocouple
(Temperature)
PBMV – Probe Millivolts
PBCF – Probe CO Factor
PBPF – Probe Process Factor
By pressing the circular arrow button
again, the following screen is shown:
The abbreviated headings for the
columns represent:
%O2 – Percent Oxygen
FLOW – Flow Rate (0 to 100
represents 0.0 to 2.0 SCFH)
ShmF – Infrared Shim Factor
Adjustment Setting
CH4F – Infrared CH4 Factor
Adjustment Setting
IRkP – Sample Pressure in KiloPascals
Pressing the circular arrow button
again will return you to the first set of
variables.
Session - Menu Page 14
Session page will allow the user to
start a session on the PGA. A session
will allow the user to identify the
operation of the PGA and break all of
the logged data into manageable
sections. Sessions can be viewed on
a computer with the XGA Viewer
software. For instance, when testing
a generator, the user can start a
session that will indicate that the
generator is being tested, when it
was tested, where it was tested, how
long it was tested, and who did the
testing. The first line, “Initiate session (1):” will allow the user to start a session on the PGA
.
Note: Even though this is the first line on the screen, it will be the last line used, since all of
the data entry lines are below . The next line, “Operator:” will allow the user to scroll through
the list of operators in the PGA. The user can either enter a number corresponding to the
location of the operator in the list, or the user can cycle through the operators by pressing
the circular arrow key. For example, if the list of operators was: J. Doe, B. Smith, and C.