Verilink PRISM 3060-10 (34-00252.4) Product Manual - Manual (Page 65)

Configuration Screens 57
Port
Parameters
The Port Configuration screen (Figure 4-14) allows viewing and setting
configuration parameters for the DSU MP unit.
It is very important that the DTE ports at opposite ends of a link be configured
identically. For example, if port A of one DSU MP is configured for 19.2 kbps async,
then port A at the far end must also be configured for 19.2 kbps async. Neglecting to do this
may not only result in the inability to pass DTE traffic from end to end, but also misdirect
data intended for one port (ex. A) to the opposite port (ex. B) at the far end. This data
swapping is a side effect of the rate-swapping feature and only occurs at DTE rates of 31.2
kbps (in TXP-I mode) and 38.4 kbps (in TXP-II mode) when units are configured improperly.
To send a new configuration to the unit, press Enter on one of the fields or exit the
screen. The underlined values are the factory default parameters stored in ROM.
This screen has the following fields, most of which have user-selectable options.
To send a new port configuration to the unit, either press Enter on one of the fields
or change the Port #, change the Element selection, or exit the screen.
Channel Allocation
A detailed description of this field is described in Channel Allocation on page 54.
Port #
This parameter allows selecting the configuration of the slot (3 through 6), DSU (1
through 6), and the port.
The following parameters are for the displayed slot and port.
Card Type
This display-only field shows what kind of card is in a given slot.
✍
3060 DSU x.xx/x.xx PRISM 3060 Date: MM/DD/YY
3060 DSU x.xx/x.xx TXPORT Prism 3060-10 Time: HH:MM:SS
PRISM Port CONFIGURATION
Element: [ ]
422222 2+2+2+ 333333 11111+
Channel Allocation: 1AAAAA BXBXBX 123456 *****R
Signalling Enabled: ------ ------ ------ ------
Port #: [4-1A ]
Card Type: Hex DDS V.54 Loop : [Enable]
DDS Mode: [DDS-1 ]
DDS Rate: [56000 ] CTS Control: [Force True ]
Start Ch. #: ( 1) DSR Control: [Force True ]
Port Rate: [56000 ] DCD Control: [Force True ]
Port Format: [SYNC ] RTS Control: [Force True ]
Port Mode: [NON-TDM ] LL Detect: [Force True ]
Port Type: [V.35 ] RL Detect: [Force True ]
Tx Clock: [Internal ] Alarm On DTR Loss: [Disable]
------------------------------------Messages------------------------------------
Local Screen
igure 4-14 DSU MP Port Configuration Screen