Watson-Marlow FF30 V2 - Manual (Page 14)

INSTRUCTION HANDBOOK
FF30 V2
FF30 IH EN 74-216-201 v1.20.doc Page 14 of 26
4 Daily Use
4.1 Starting-up and running
Installation section must be carried out before this chapter can be performed.
When the main switch is turned, an initial procedure starts and secure that the machine is ready for
production. The POWER ON will light if no errors are detected.
In case of error detection during initial procedure the ALARM button will flash.
See section 5 regarding alarms.
4.1.1 Adjusting the round table inner bottle rail
Adjust the inner bottle rail by loosening the
bolts (finger screws) and move the rail in or
out; depending on bottle size. The bottles
should be stopped by the rail in such a way
that only one bottle at a time can pass the
space between the inner and outer rail.
4.1.2 Adjusting the inlet guide
Adjust the inlet guide by loosening the bolts (finger screws) and move it to the right or left; depending
on bottle size. The bottles should be let to the first position of the star wheel; never to the outside of
the star wheel.
Correct adjustment Wrong adjustment