2 general information, 1 unpacking and inspection, 2 receiving and storing the ff30 – Watson-Marlow FF30 V2 User Manual
Page 6: 3 mounting of support for inlet and outlet tray, General information, Unpacking and inspection, Receiving and storing the ff30, Mounting of support for inlet and outlet tray, Instruction handbook
INSTRUCTION HANDBOOK
FF30 V2
FF30 IH EN 74-216-201 v1.20.doc
Page 6 of 26
2 General information
2.1 Unpacking and inspection
Please check that all ordered items have been received and that no items are damaged during
transport. In case of any defects or omissions, please contact WMF or your supplier immediately.
2.2
Receiving and storing the FF30
Before unpacking or storing of the FF30 it should be checked if the crate is damaged.
In case of long-term storage of the FF30 before installation, the machine must be stored in the crate,
and placed in a dry room. The crate is not water resistant.
2.3
Mounting of support for inlet and outlet tray
If the inlet tray or outlet tray have been removed during shipping they must be mounted as shown
below. Use the supplied bolts and fasten them as shown below.
Inlet tray
Outlet tray