Westermo ED-20 - Manual (Page 15)

15 6609-2222
6.4 MAC address
The MAC address of the unit can be found on the product label “00 30 56 F” + last 5
digits on IC2 see figure in section 6.3 Switch settings on page 13. Example: Label on IC2
“SC12 RTOS 0092C2” this will give the unit MAC address “00 30 56 F0 92 C2”
The MAC address can also be find out with the DOS command “ARP –a”. (Perform the
“PING” command with the ED-20 local IP address before the ARP command.)
6.5 Installation of ED-Tool for ED-20
This section describes the installation of ED-Tool for ED-20.
System Requirements:
To install and run the ED-Tool for ED-20 program following requirements are needed.
Minimum:
… 386, 486 or Pentium‚ Processor-based personal computer
… Microsoft‚ Windows‚ 95/98/Me,Windows NT 3.51/4.0‚
or Windows 2000‚ Windows XP, compatible OS
… 16 MB of RAM for Windows 95/98/Me systems
… 24 MB of RAM for Windows NT systems
… 32 MB of RAM for Windows 2000/XP systems
… CD-ROM drive
… 8 MB of space on hard drive
… Serial and/or Ethernet network connections
… Internet Explorer 5.0 or higher
Recommended:
… Pentium processor-based personal computer
… 32 MB of RAM
Installation:
To install ED-Tool for ED-20
… Insert the ED-Tool for ED-20 CD-ROM into the CD-ROM drive
… Locate the ‘setup.exe’ file on the ED-Tool for ED-20 CD-ROM
… Run the ‘setup.exe’ and follow the instructions