Westermo ED-20 User Manual
Page 19
19
6609-2222
8.1.1 ED-Tool for ED-20 commands
This section describes the ED-Tool for ED-20 commands.
The commands are described by there use.
Details about allowed values and default values is described is section 8.2.
8.1.1.1 General commands
1
Selects type of connection, Serial or over the Network.
If ‘Serial’ is selected, use the “Tools menu – Serial COM port” to
select which of COM1:, COM2:, COM3:, or COM4: your serial
cable is connected to.
2
Read Config
Reads configuration from the ED-20.
3
Write Config
Writes configuration to the ED-20.
Note! ED-20 must be rebooted before any new configuration
is activated.
4
Reboot
Reboots the ED-20.
8.1.1.2 Serial Interface – Channel 1 specific commands
Communication
5
Data Rate
Selects Data Rate for serial communication, ED-20 – Modem.
6
Flow Control
Selects if flow control is used or not.
Note! All interconnecting wires are required between the ED-20
and the attached modem.Flow control must be set to none
when using RS-422.
57600
RTS/CTS
1
2
3
4
5
6