Westermo ED-20 - Manual (Page 30)

30 6609-2222
Remote address*
When the ED-20 is in server mode, this will be the Clients IP address on the PPP link
Allowed values: Should be in decimal dotted notation And have the same
Network ID as Local IP and different then Local IP
Default: 169.254.200.101
Subnet Mask*
Set a valid subnet mask in decimal dotted notation.
Default: 255.255.255.0
Ethernet Interface
Local IP Address*
This is the address of the router and this address shall be used as default gateway in
the units that will use the ED-20 as a gateway.
Set the local IP address in the rage of the Network ID.
Note! The Network ID must be different than the Network ID on the PPP link
and the Network ID on the other network.
Allowed values: Should be in decimal dotted notation in one off the following ranges:
1.0.0.0
126.0.0.0
128.1.0.0 191.255.0.0
192.0.1.0 223.255.255.0
Default: 169.254.100.100
Subnet Mask*
Set a valid subnet mask in decimal dotted notation.
Default: 255.255.255.0
Prox Arp
Enable or disable the Proxy ARP function with the radio buttons.
Default: OFF
8.2.4 Brouter settings
The brouter function will initiate outgoing connections.
This function is only available in PSTN + Dial Out mode
(Refer to section 8.2.2 – General – Modem settings and Dial IN/OUT.)
When a IP packet sent to the ED-20 have a IP Address that match a IP Address in the
entry list, the ED-20 will send the connect message to the attached modem.This will
result in an connection to another location and establishment of a PPP link.
Note! Since the ED-20 and the attached modems need some time to establish a modem
connection and a PPP link,The IP packets sent before the PPP link is ready may be
lost depending of the application used.
* The IP address must be compliant to the attached network. Ask the network administrator when in doubt.
Ethernet Interface