AEC OS Series Gravimetric Batch Blenders - Manual (Page 32)

Page 31 of 118
Twist Cap Plug Connected to Each Auger Motor (OA Blender only)
The cap plug must be turned counter-clockwise to loosen and the female
end of the cord removed from the motor plug. This disables the motor
from turning while the auger unit is being serviced or cleaned. The motor
cords are cut to length so they must be disconnected before the auger
can be removed from the housing. Disconnect plug before cleaning or
servicing motors or augers.
Motor
Unscrew and remove plug
from motor
WARNING!
At no time must anyone remove the lockout or reconnect
the twist plug, other than the person who installed the
lockout or who unplugged the twist plug.