AEC OS Series Gravimetric Batch Blenders - Manual (Page 66)

Page 65 of 118
5-8-13 Feeder Metering Order
The HydReclaim OS/OA blender allows the user to set the ingredient
metering order. In order to access the metering order menu, enter the
Recipe menu (refer to the menu structure on page 51). Once in the
recipe menu, select #3 option (Metering Order). This display will
indicate the feeder number and the current order in which the
ingredients are metered.
In order to change the metering order, simply press the feeder number
you wish to change. The order number located on the display next to
the feeder number is implemented. Once the desired metering order is
displayed, simply press the <BACKUP> key to save the information
and exit from the menu.
Important!: All feeders must be in the metering order. Do not have the same
metering order number assigned to two feeders at the same time
as the control will not accept the settings.
5-8-14 Remote Control Panel (RCP)
Note: RCP is an option that provides a second operator control.
This section describes the optional HydReclaim Remote Control Panel
(RCP). The RCP is useful in situations when the access to the control
panel is difficult or limited. This remote control panel may be located up
to 300 cable feet away from the blender control panel. (Note: a signal
amplifier may be required for long distances. Consult factory with actual
application.)
The RCP provides the operator with all the functions of the standard
OS/OA control panel. The keypad and display are identical to the
blender panel.
Every OS/OA blender panel includes an RCP connection, and the RCP
simply plugs into the appropriate connector on the back control panel.
The RCP is an option to the blender and is not included with the
standard blender.