Removing the blackdiamond 8806 ac power cord, S into the channel (see, Figure 85 – Extreme Networks BlackDiamond 8800 Series User Manual
Page 130
BlackDiamond AC Power Cord Retaining Brackets
BlackDiamond 8800 Series Switches Hardware Installation Guide
130
Figure 85: Routing the Power Cords in the Channel
NOTE
Leave the ESD-preventive wrist strap permanently connected to the switch, so that the strap is always available
when you need to handle ESD-sensitive components.
Removing the BlackDiamond 8806 AC Power Cord Retainer
Channel
To remove the BlackDiamond 8806 AC power cord retainer channel:
1
Attach the ESD-preventive wrist strap to your wrist and connect the metal end to the ground
receptacle on the top-left corner of the switch front panel.
2
Using a #2 Phillips screwdriver, loosen the captive screw located on each end of the AC power cord
retainer channel.
3
Remove the retainer channel from the switch.
NOTE
Leave the ESD-preventive wrist strap permanently connected to the switch, so that the strap is always available
when you need to handle ESD-sensitive components.
From the left, lay first four
power cords into channel bracket
Lay last two power cords
onto others