Extreme Networks BlackDiamond 8800 Series - Manual (Page 150)

Repacking a BlackDiamond 8800 Series Chassis
BlackDiamond 8800 Series Switches Hardware Installation Guide 150
Repacking the BlackDiamond 8806 Chassis
To repack the BlackDiamond 8806 chassis:
1 Attach the ESD-preventive wrist strap to your bare wrist and connect the metal end to the ground
receptacle on the chassis front panel.
2 Remove all modules and power supplies from the BlackDiamond 8806 chassis. Follow correct
Extreme Networks procedures for removing components.
3 Using four rack mounting screws, attach the 19-inch helper bracket to the system rack immediately
below the chassis.
4 Remove the eight rack mounting screws that secure the chassis to the system rack.
5 On each side of the chassis, place one hand in the empty power supply bay and the other hand in
the recessed hand-hold on the back panel of the chassis.
CAUTION
Do not use the fan tray handle to lift or maneuver the BlackDiamond 8806 chassis. This handle is not designed to
support the weight of the chassis.
6 Slowly guide the chassis out of the system rack using the helper bracket for support.
7 Carefully lift the chassis off the helper bracket and lower it onto the foam cushion in the shipping
carton base (see
Figure 103 .)
Figure 103: Setting the BlackDiamond 8806 Chassis onto the Foam Cushion
EX_129