Extreme Networks BlackDiamond 8800 Series - Manual (Page 97)

Installing an Extreme Networks 1200 W DC PSU
BlackDiamond 8800 Series Switches Hardware Installation Guide 97
5 Connect the input DC cable to the front of the 1200 W DC PSU as shown in Figure 55 .
NOTE
An AC power cord is not required for proper functioning of the DC PSU.
6 Rotate the locking handle down to latch the input cable connector onto the DC PSU.
Figure 55: Connecting the Input Cable to the 1200 W DC PSU
7 Secure the 1200 W DC PSU in the power supply bay by pushing down on the locking handle until it
clicks in place.
NOTE
The DC PSU does not energize until the locking handle latches.
CAUTION
When you route the DC cable harnesses, minimize stress on the cables. It is important to route each of the
outermost cables out the opposite side of installation to maximize the bend radius and to avoid stress on the cables.
For example, you should route the leftmost cable harness across the switch so that it exits through the right side of
the grate. Route the rightmost cable harness across the switch so that it exits through the left side of the grate. The
four middle cables can route in either direction.
8 Energize the DC circuit for the 1200 W DC PSU.
To install additional 1200 W DC PSUs, repeat steps 2 through 8 .
EX_132
Locking
handle
open
Locking handle closed
traps DC plug
Remove/insert
DC plug
Yellow
lever