AML M2800 - Manual (Page 10)

Model M2800 USB Bar Code and Magnetic Card Reader
Page: 10
©2005 American Microsystems, Ltd. All Rights Reserved
2190 Regal Parkway • Euless, TX 76040
Phone 817.571.9015 • Fax 817.571.6176
Web Address: www.amltd.com
CODE 39
0) CODE 39 DECODER
ON* Enable reading Code 39 labels.
OFF Disable reading Code 39 labels.
1) FULL ASCII
ON Enable the Full ASCII Extension to Code 39. Option #0 above must be set on.
OFF* Disable the Full ASCII Extension to Code 39. This sets the M2800 to the standard Code 39
mode.
2) MOD 43 CHECK DIGIT
ON Enable the Mod 43 Check Digit for Code 39. When this option is enabled, only Code 39 labels
that contain a valid check digit will be read.
OFF* Disable the Mod 43 Check Digit. Check digit verification will not be performed.
3) SEND CHECK DIGIT
ON Transmit the Mod 43 Check Digit with the bar code data. Requires option #2 above to be set on.
OFF* Do not transmit the Mod 43 Check Digit.
4) CONCATENATE MODE
ON Enable Concatenate Mode. The concatenate mode allows the M2800 to accumulate multiple bar
codes in its buffer, and then sends them to the computer just like they were a single bar code.
When a Code 39 label containing a leading space is read, the M2800 emits two short beeps and
buffers the data without transmission. This process continues until a Code 39 label without a
leading space is read or 128 characters are buffered. A Code 39 bar code label that only contains
a single or multiple dashes (minus sign) will clear the buffer.
OFF* Disable Concatenate Mode.
UPC
0) UPC DECODER
ON* Enable reading UPC-A and UPC-E labels.
OFF Disable reading UPC-A and UPC-E labels.
1) CONVERT UPC-E TO UPC-A
ON Convert all UPC-E labels to their UPC-A equivalents (zero-fill) before transmission. After
conversion, the M2800 will follow the UPC-A programming options.
OFF* No conversions will be performed.
2) CONVERT UPC-A TO EAN-13
ON Convert all UPC-A labels to an equivalent EAN-13 format by inserting a leading zero. After
conversion, the M2800 will follow the EAN-13 programming options.
OFF* No conversions will be performed.
3) SEND UPC-A NUMBER SYSTEM
ON* Transmit the UPC-A Number System character.
OFF Do not transmit the UPC-A Number System character.
4) SEND UPC-E NUMBER SYSTEM
ON* Transmit the UPC-E Number System character.
OFF Do not transmit the UPC-E Number System character.
5) SEND UPC-A CHECK DIGIT
ON* Transmit the UPC-A Check Digit character.
OFF Do not transmit the UPC-A Check Digit character.
6) SEND UPC-E CHECK DIGIT
ON* Transmit the UPC-E Check Digit character.
OFF Do not transmit the UPC-E Check Digit character.