Page: 18 – AML M2800 User Manual

Page 18

Advertising

Model M2800 USB Bar Code and Magnetic Card Reader

Page: 18

2190 Regal Parkway • Euless, TX 76040

Phone 817.571.9015 • Fax 817.571.6176

Web Address: www.amltd.com

5) SERIAL SEND DELAY (0.0 - 9.9 SEC)

This option specifies the amount of delay to occur after the serial port preamble is transmitted. The delay
period is programmable from 0.0 to 9.9 seconds.

6) ACTIVE TYPES

Specifies the types of bar codes that use preambles. Select one of the following:

A Code 39

E EAN-8

I Code 93

M RSS14

B UPC-A

F I 2 of 5

J MSI/Plessey

N RSS Limited

C UPC-E

G Codabar

K Code 11

O RSS Expanded

D EAN-13

H Code 128

L ISBN

X* All Bar Codes

POSTAMBLE

Postamble refers to a user-defined set of characters transmitted at the end of each type of input data. There are
three different postambles with one set each for bar code data, magnetic stripe data, and serial input port data.

0) ENTER BAR CODE POSTAMBLE

This set of user-defined characters is transmitted at the end of bar code data. To define this postamble,
scan up to 15 characters from the Full ASCII Chart on the reverse side of the M2800 Setup Menu. Scan
the ON bar code when complete. Scan OFF to completely erase or disable the postamble.

1) ENTER MAG STRIPE POSTAMBLE

This set of user-defined characters is transmitted at the end of magnetic stripe code data. To define this
postamble, scan up to 15 characters from the Full ASCII Chart on the reverse side of the M2800 Setup
Menu. Scan the ON bar code when complete. Scan OFF to completely erase or disable the postamble.

2) ENTER SERIAL PORT POSTAMBLE

This set of user-defined characters is transmitted at the end of serial port data. To define this postamble,
scan up to 15 characters from the Full ASCII Chart on the reverse side of the M2800 Setup Menu. Scan
the ON bar code when complete. Scan OFF to completely erase or disable the postamble.

3) BAR CODE SEND DELAY (0.0 - 9.9 SEC)

This option specifies the amount of delay to occur after the bar code postamble is transmitted. The delay
period is programmable from 0.0 to 9.9 seconds.

4) MAG SEND DELAY (0.0 - 9.9 SEC)

This option specifies the amount of delay to occur after the mag stripe postamble is transmitted. The
delay period is programmable from 0.0 to 9.9 seconds.