Page: 9, Programming guide – AML M2800 User Manual
Page 9
Model M2800 USB Bar Code and Magnetic Card Reader
Page: 9
©2005 American Microsystems, Ltd. All Rights Reserved
2190 Regal Parkway • Euless, TX 76040
Phone 817.571.9015 • Fax 817.571.6176
Web Address: www.amltd.com
PROGRAMMING GUIDE
START
The START bar code places the M2800 into the program mode. After scanning this label, the M2800 will emit
three short beeps to indicate that it is in the program mode.
EXIT (SAVE CHANGES)
Scan this bar code to EXIT the program mode and save all of the changes. After scanning this label, the M2800
will beep twice then delay approximately one second and emit three short beeps to indicate that it accepted the
changes.
EXIT (IGNORE CHANGES)
Scan this bar code to EXIT the program mode and discard all of the current changes. The M2800 will use the
settings that were in effect before entering the program mode.
RESET ALL DEFAULTS
Scan this bar code to reset all options to their default settings.
NOTE: Defaults are marked with an asterisk (*).
0-9 BAR CODES
These bar codes are scanned to select various options and enter programmable data into the M2800.
NOTE: Scan option 9 to reset all of the options within the current category back to their defaults.
ON
If the OPTION has an (ON/OFF) beside the description, scan the ON bar code to turn on the current option.
OFF
If the OPTION has an (ON/OFF) beside the description, scan the OFF bar code to turn off the current option.
FULL ASCII CHART
The Full ASCII Chart is located on the back of the M2800 Setup Menu. This chart contains the entire ASCII
character set (128 characters). Use this chart to enter Preamble and Postamble character strings as well as the
Record Terminator and Separator characters.
ADDITIONAL NOTES:
If the description beside the option contains:
(ON/OFF)
Scan either an ON or OFF label to set the option.
(CHART)
Scan one or more characters from the Full ASCII Chart.
(0 – 9)
Scan the desired character from the 0-9 labels.
(0.0 – 9.9)
Scan two characters from the 0-9 labels to set the time from 0 to 9.9 seconds.