Turning the unit on and off – Panasonic Toughpad FZ-F1 User Manual
Page 27
27
Getting Started
• The unit prevents overcharging of the battery by charging only
when the remaining battery level is less than approximately 95 %
of its full capacity.
• You can also charge the unit by connecting it to the USB port of a
computer or other device using a USB connection cable.
Note
• When removing the USB connection cable, make sure to
remove it while holding the plug. Do not pull by the cable.
• When connecting a USB connection cable, note the shape of
the micro USB plug and the micro USB port. Do not attempt to
connect the USB connection cable upside down.
• Remove any dust or water droplets from plugs before
connecting them. Do not use excessive force when inserting
plugs or insert them at an angle.
Confirming the battery level
The battery level is displayed in the upper-right corner of the screen,
in the status bar.
You can also confirm the specific amount of battery level remaining.
Flick the Start screen to the left, and then in the All apps list, tap
[Settings]
[System] [Battery saver].
Turning the unit on
Press and hold
(power button) on the top of the unit until the unit
briefly vibrates.
Turning the unit off
1. Press and hold
(power button) until [slide down to power
off] is displayed.
2. Tap the screen and slide your finger down.
Fully
charged
Charging
Very low
Turning the unit on and off