Grass Valley Jupiter v.1.0 - Manual (Page 65)

Jupiter L-S Series Control Panels Installation and Operating Manual 65
L32/L64 Control Panels
Breakaway Source Status
To identify which sources are currently switched to the levels of a destina-
tion:
1. Confirm the destination you want to examine appears in yellow in the
Destination window.
2. Press just the Level button.
3. Use the Up/Down arrow buttons to view the status of each level. The
name of the current source will be displayed in green along with the
name of the level. If that source button is assigned on the panel it will
illuminate.
4. Press the Level button again to turn off the mode.
Sticky Levels Mode
You can turn on Sticky Levels mode to keep active only the last selected
levels after a breakaway take.
1. Press the Menu button, use the Up/Down arrow buttons to scroll to Panel
Config? and press Take.
2. The Sticky Level menu will be displayed with its current status (ON or
OFF).
3. Press Take to toggle the state ON or OFF)
4. Press Clear to escape configuration mode.
Executing a Sequence (Salvo)
After a sequence is created and downloaded (see Setting Up a Salvo with a
Sequence Set on page 52 ) it can be executed as follows:
Direct Execution
In order to directly execute a sequence, that must be assigned to a panel
button (see
Button Assignment on page 67 ).
1. Press the assigned Sequence button for the desired sequence.
All the destinations in the sequence will immediately be switched to their
designated sources.