Sybase 11.9.x-12.5 - Manual (Page 17)

CHAPTER 4 Backup Server Error Messages
691
minor numbers order the errors within a major category. There is no special
meaning to these numbers; they serve only to distinguish between errors.
severity codes are as follows:
state codes have a one-to-one mapping to instances of the error reported within
the code.
List of Error Messages
Note Any “shortage of memory” message may indicate that both swap and
physical memory are in short supply. Increasing either may avert this error.
Make sure that you have enough physical memory so that Adaptive Server and
Backup Server can run without being swapped.
1 Critical errors
2 Open Server event errors
3 Backup Server RPC API errors
4 I/O service layer errors (that is, operating system I/O calls)
5 Network data transfer errors
6 Archive volume manipulation errors
7 Parser errors (errors in the dump or load command options)
8 Tape auto configuration errors
Severity Code Description
0 Internal informational message, usually a component of another message.
No user action necessary.
1 Information, no user action necessary.
2,3 An unexpected condition, possibly fatal to the session, has occurred. Error
may have occurred with any or all of usage, environment, or internal logic.
This severity consists of two levels, which indicate whether or not the
session must exit. 2 indicates the session must exit. 3 indicates the session
may or may not exit.
4 An unexpected condition, fatal to the execution of the Backup Server, has
occurred. The session must exit immediately.