Server error messages 1 - 199 – Sybase 11.9.x-12.5 User Manual
Page 83
CHAPTER 6 Adaptive Server Error Messages
757
Server Error Messages 1 - 199
Number
Severity
Text and Explanation
21
10
WARNING - Fatal Error %ld occurred at %S_DATE. Please note the error and time,
and contact a user with System Administrator (SA) authorization.
Explanation:
This is an informational message. Unless otherwise specified, no action
is required. Contact your System Administrator about any warning issued in the
message.
101
15
Line %d: SQL syntax error.
Explanation:
Command failed. Check syntax and semantics.
102
15
Incorrect syntax near `%.*s'.
Explanation:
Refer to the writeup for Error 102.
103
15
The %S_MSG that starts with `%.*s' is too long. Maximum length is %d.
Explanation:
Command failed. Check syntax and semantics. Rewrite the command to
satisfy the condition indicated in the message.
104
15
Order-by items must appear in the select-list if the statement contains set operators.
Explanation:
Command failed. Check syntax and semantics. Rewrite the command to
satisfy the condition indicated in the message.
105
15
Unclosed quote before the character string `%.*s'.
Explanation:
Command failed. Check syntax and semantics. Rewrite the command to
satisfy the condition indicated in the message.
106
16
Too many table names in the query. The maximum allowable is %d.
Explanation:
Command failed due to invalid or illegal request. Check syntax,
semantics, and permissions. Take any corrective action indicated by message.
107
15
The column prefix `%.*s' does not match with a table name or alias name used in the
query. Either the table is not specified in the FROM clause or it has a correlation name
which must be used instead.
Explanation:
Refer to the writeup for Error 107.
108
15
The order-by position number `%ld' is out of range of the number of items in the select-
list.
Explanation:
Command failed. Check syntax and semantics. Rewrite the command to
satisfy the condition indicated in the message.
109
15
There are more columns in the INSERT statement than values specified in the VALUES
clause. The number of values in the VALUES clause must match the number of columns
specified in the INSERT statement.
Explanation:
Command failed. Check syntax and semantics. Rewrite the command to
satisfy the condition indicated in the message.