Sybase 11.9.x-12.5 - Manual (Page 548)

Server Error Messages 14000 - 14099
1222
Server Error Messages 14000 - 14099
13940 16 One or more column names in the specified table contain reserved words or special
characters, for example ’%.*s’. Set the QUOTED_IDENTIFIER option to handle the
column(s) and re-run the command.
Explanation: Adaptive Server could not perform the requested action. Rewrite the
command to conform to the requirement specified in the error message.
Number Severity Text and Explanation
Number Severity Text and Explanation
14000 10 per object statistics active determines whether the Adaptive Server will collect
monitoring information on a per object basis
Explanation: This is an informational message. Unless otherwise specified, no action is
required. Contact your System Administrator about any warning issued in the message.
14001 10 per object statistics active determines whether the Adaptive Server will collect
monitoring information on a per object basis
Explanation: This is an informational message. Unless otherwise specified, no action is
required.
14002 16 The configuration option ’dtm detach timeout period’ specifies the timeout period in
minutes, for detached transactions. Transactions that are detached longer than this
timeout period will be rolled back.
Explanation: Command failed due to invalid or illegal request. Check syntax,
semantics, and permissions.
14003 10 The ’abstract plan load’ option enables the server wide Abstract Plan LOAD mode from
ap_stdin.
Explanation: This is an informational message. Unless otherwise specified, no action is
required.
14004 10 The ’abstract plan dump’ option enables the server wide Abstract Plan DUMP mode to
ap_stout.
Explanation: This is an informational message. Unless otherwise specified, no action is
required.
14005 10 The ’abstract plan replace’ option enables the server wide Abstract Plan REPLACE sub-
mode.
Explanation: This is an informational message. Unless otherwise specified, no action is
required.