iSys i36 - Manual (Page 8)

i36 ImageMaster User Guide 9
3
AC Power Cable - 220/230 Volt
CAUTION: Read the following procedure before connecting to a 220/230 volt
power source. The i36 ImageMaster power supply is not auto-switching.
Improper connection to a 220/230 volt power source will cause sever damage
to the PC/RIP and plotter.
CAUTION: The electronic components of the i36 ImageMaster can be
damaged by electrostatic discharge (ESD). To avoid ESD, maintain contact
with a ground source. A grounded wrist strap or similar device should be used.
WARNING: Electric shock warning.
NOTE: An optional 220/230 volt power cable is required for this procedure. Contact
iSys technical support for more information.
1. Remove the two screws in Figure 1 (7).
2. Locate the switches on the back of the power supply (see Figure 2).
3. Set the switch to 220/230 V.
4. Close hinged cover and replace screws.