Linkskey LKV-IOP08 - Manual (Page 12)

ioPower User Guide Flash Upgrade Operation Guide
Rev. 1.41 Copyright© All rights reserved. Feb 2005 9
Step 8. After you have successfully upgraded the flash
firmware and before you utilize the ioPower Unit,
you should perform a system reset by powering
down the unit. Wait for a few seconds and then
complete the reset again.
Troubleshooting
If the flash upgrade procedure seems never ending or you
see the following message: Please send new firmware, shown on
the screen, it indicates that the flash process had failed. If that is
the case, please power off the ioPower Unit and then power it
on restart the whole flash procedure again. You also press any
button on front panel about 3 seconds when you power on the
ioPower Unit.