Magnum Energy Series Stacking Cable Kit (ME-SSI) - Manual (Page 9)

©
2010 Magnum Energy, Inc.
Installation
DC Wiring Using One Battery Cable Pair – Both inverters
share a single battery cable pair (one positive and negative). It is
divided between the two inverters and is protected by a single DC
disconnect/overcurrent device. The positive battery cable is con-
nected to the positive terminal of one inverter and the negative
battery cable is connected to the negative terminal of the other in-
verter. This is to ensure an even charge and discharge through the
batteries. The positive and negative interconnect cables provided
are used to place the inverters as close to each other as possible.
•
Figure 3, DC Wiring Using One Battery Cable Pair
4
6 volt
battery
6 volt
battery
6 volt
battery
6 volt
battery
6 volt
battery
6 volt
battery
6 volt
battery
6 volt
battery
This diagram is for a 24 VDC
battery system. Ensure your
battery bank is wired correctly .
This battery bank uses two battery strings . They must
be connected together in parallel to provide a single
battery bank to the inverters .
DC Positive and
Negative Interconnects
(from ME-SSI kit)
MS4024
L1
inverter
MS4024
L2
inverter
DC disconnect and
overcurrent
protection
Stacker cable
(from ME-SSI kit)