Eaton Electrical Powerware 9315 - Manual (Page 28)

Using the Monitor Panel
5-2 EATON Powerware
®
9315 UPS (200–300 kVA) Operation Manual S 164201036 Rev F powerware.com
5.1 Using the LCD Screen
The LCD screen at the top of the Monitor Panel provides an operator interface with the
UPS. Figure 5-2 identifies the display fields discussed in the following sections.
Uninterruptible Power System
System Normal
Alarm: None
Notice: None
Meters
System
Load Amps
Events Statistics Graphics Setup
Input Output
Bypass Battery
VAB
480
VBC VCA
KW
379
KVA
399
IA IB IC
FREQ
60.0
PF
0.95
V
540
I
000
Meters
480
480 480
480 480
VAB
480
VBC VCA
480 480
IA IB IC
361 361 361
IN
000
VAB
480
VBC VCA
480 480
FREQ
60.0
KVA
300
KW
240
PF
0.80
Battery
04 MAY 1997 14:23:45
100%
Percent
B
C
D
E
A
F
G
Figure 5-2. Parts of the LCD Screen (Typical for Powerware 9315 300 480/480V UPS)
A The UPS status area contains three lines that display the current state of the UPS. The first line
shows the present operational mode of the UPS. The second line shows the highest level of the
current active alarms, and the third line shows any notices the UPS has posted. (For more
information about alarms and notices, see Chapter 10, “Responding to System Events.”)
B The battery charge box shows the percentage of battery capacity available.
C The menu box shows the currently selected menu and lists the options available on that menu. The
title at the top of the menu box is also shown below on the menu bar (E). Press the and
buttons to scroll up and down through the options in the menu box.
D The currently selected option is highlighted in the menu box. Press the and buttons to move
the highlight up or down. The data in the information area (G) changes accordingly.
E The menu bar lists the titles of the menus. The title of the menu currently displayed in the menu
box is highlighted. When you press the and buttons to move the highlight left or right, the
data in the menu box and the information area change accordingly.
F The timestamp shows the current date and time. This date and time are recorded in the Event Log
when a notice or alarm is activated.
G The information area contains data about UPS status and operations. Select a menu option to
display statistics or graphics.