Elmo Network Pan-Tilt-Zoom Camera PTC-201CIP - Manual (Page 18)

- 17 -
[5] BLC (Back Light Control)
In case the back lighting is too bright to shoot the
main object clearly, press BACK LIGHT
button.
To cancel this mode, press the button.
14
[6] Preset operation
The Camera head direction, the zoom position, the
focus status and the brightness level can be
registered up to 6 items. The registration contents
remain retained even if the Camera power is
turned OFF.
(1) Setting presets
• Set the Camera head direction, the zoom
position, the focus status and the brightness
level.
• When PRESET button is pressed, the
LED on the Camera blinks in green (for 0.4
16
14
16
18
sec). To cancel this, press PRESET button again.
• Then, press one of the 1 through 6 buttons. Now, the registration is over, and
the LED on the Camera goes out. (The preset contents, if already registered, are
overwritten.)
(2) Execution of preset
• When one of the 1 through 6 buttons are pressed, the Camera head direction,
the zoom position, the focus status and the brightness level are set to that specific
preset position.
18
18
16