Elmo Network Pan-Tilt-Zoom Camera PTC-201CIP - Manual (Page 24)

- 23 -
DIP Switch (4)
8. INITIALIZATION OF THE CAMERA SETTINGS
The camera settings can be initialized with the DIP switch (4) located on the back panel.
• In the power supply OFF state (the AC adapter is not connected), turn ON the RESET
switch.
• Turn on the power supply (connect the AC adapter), and 10 seconds later, turn OFF
the power supply.
• When the power supply is turned on again, the PAN/TILT settings, lens settings,
preset settings, and camera settings by the OSD (on-screen display) are reset to
factory-shipped condition.
Note: After the initialization, be sure to turn OFF the RESET switch. If the
switch remains ON, every time the power supply is turned on, the
settings are initialized, so that each setting is not stored.
Note: The extension switch and N/A switch not in use must be kept OFF.
Note: When this operation is performed, the “initialization of the network
settings” (page 32) is also carried out at the same time.
Switch No.
EXTENSION
N/A
RESET
TEMINATE
Normal
OFF
OFF
OFF
OFF
Operation
ON
Kept OFF
ON OFF
ON
Function
RSU-200 (optional) mode
-
Initialization of settings
Terminator setting (see P.25.)
Switch assignment