Elmo Network Pan-Tilt-Zoom Camera PTC-201CIP - Manual (Page 29)

- 28 -
11. NETWORK FUNCTIONS
By connecting this Camera to the network using Ethernet (10BASE-T/100BASE-TX), the
following functions are made available from the host (e.g., PC) on the network:
• Web server functions – Displaying moving images, displaying static images, quad
disply and operating remote control through the Web browser.
• Alarm function - Saving image files to the remote host by input of the alarm signal.
• IP address filtering functions - Restricting clients who have access to the Camera.
• LIVE connection list - Listing the clients connected to the LIVE page.
• telnet server functions – Operating remote control and acquiring status data.
Note: It is not assured that this Camera can be connected to all units on the
network.
Note: The applicable Web browsers are Internet Explorer 4.0 and newer and
Netscape 6.0 and newer. For any other browser, consult your dealer or an
authorized ELMO service center.
[1] Preparation for connection
Before connecting the Camera to the network for use, the network must be set up (e.g., IP
address).This Camera provides two procedures for setting up the network as follows:
• Connecting the Camera from the host on the network through the Web browser.
• Connecting the Camera from the host on the network through telnet.
Here, the setup procedure using the Web browser is described.
For the setup procedure using telnet,
consult your dealer or an authorized ELMO service center .
Preparation before setting up
Before starting the setup, specify the IP address and subnet mask to be set up in the Camera.
For the IP address and subnet mask to be specified, ask the administrator of the network to
be used.
This Camera has been factory set on the network as follows:
IP address 192.168.0.100
Subnet mask 255.255.255.0
If the network address of the network to be used is not 192.168.0.0 or if there is any other
host with the IP address 192.168.0.100 is already in operation on the same network, this
Camera cannot be connected to the network for setup. In this case, a network with the IP
address 192.168.0.0 must be configured with this Camera and the host for setting up this
Camera. Prepare a host having the IP address 192.168.0.X (X: 1~254, excluding 100) and
the subnet mask 255.255.255.0, and connect such host to the Camera.