Elmo Network Pan-Tilt-Zoom Camera PTC-201CIP User Manual
Page 32
- 31 -
Initialization of the network settings
If the connection from the network is disabled due to destruction of the network settings or
disremembering of the set value, reset the settings to the factory settings by using the
following procedure and then redo the settings:
• If the Camera is in connection to the network, disconnect the Camera from the
network.
• In the power supply OFF state, turn ON the RESET switch located on the backside of
the Camera.
• Turn ON the power supply, and wait for approx. 10 seconds.
• Turn OFF the power supply, and turn OFF the RESET switch.
• Turn ON the power supply again. Then, the network settings, IP adrress filtering
setting, alarm setting, quad display setting are reset to the factory settings.
Note:
After the initialization, be sure to turn OFF the RESET switch. If the switch
remains ON, every time the power supply is turned on, the settings are
initialized, so that each setting is not stored. Besides, the connection from the
network is disabled.
Note: When this operation is performed, the camera settings are also initialized.
(Refer to [8] “Initialization of the camera settings” on page 23.)
[2] Web server functions – Displaying moving images, displaying
static images, quad disply and operating remote control through the
Web browser.
When the Camera is connected from the Web browser, moving images can be displayed,
static images cab be displayed, and remote control can be operated. To connect the Camera
from the Web browser, enter the IP address or host name (if allocated) of the Camera,
following [http://], in the address column of the Web browser provided for entering the
URL to be opened. Then, the PTC-201C IP page is displayed. Click the desired link there.
Then, the selected function can be used.
If the password has been set on the
[Network Configuration]
, the Authentication page is
displayed. In that case, if authentication by the [root], [operator], or [user] account is
cleared successfully, the Web server functions can be used.
Reference Page [7] Configurations
Network Configurations P.43
Note:
Since no password is factory set, the Authentication page is not displayed.