Elmo Network Pan-Tilt-Zoom Camera PTC-201CIP User Manual
Page 36
- 35 -
About control
Remote control of the Camera can be accomplished by only one client. Control is given to
the client who satisfies the following conditions.
• Client who has been authenticated by the [root] or [operator] account in the case
where the password is specified for [operator] or [user] on
[Network Configuration]
page. (Refer to the paragraph “Network Configurations” in [7] “Configurations” on
page 43.)
• All clients when in as-shipped condition (no password is set).
Control is transferred on an earlier authenticated client basis.
For example, in the case where the client who obtained control when multiple clients were
displayed on the LIVE page leaves the LIVE page, control is transferred to the client
displayed in the mode incapable of remote control. Then, it is undefined to which client
control is transferred next.
Note:
Depending on network environments, control is not transferred immediately.