Eaton Electrical Powerware 5130 Rack/Tower UPS 1250-3000 VA - Manual (Page 36)

INSTALLATION
EATON Powerware ® 5130 Rack/Tower UPS (1250–3000 VA) User’s Guide S 164201730 Rev 2
www.powerware.com
30
5. Plug the equipment to be protected into the appropriate UPS output
receptacles (see page 42 for more information on load segments).
See Figure 10.
NOTE DO NOT protect laser printers with the UPS because of the exceptionally high power
requirements of the heating elements.
6. High-voltage models only. Install the cord-retention bracket to secure
the cords and provide strain relief (see Figure 10).
Plug a 10A power cord into the input connector on the UPS rear
panel (16A power cord supplied for 2500–3000 VA models).
Figure 10. Installing the Power and Equipment Cords (High-voltage only)
7. If you are installing a remote power-off (RPO) or a remote on/off
(ROO) switch, see the following section, “RPO and ROO
Installation,” to install the switch before powering on the UPS.
8. Continue to “Turning the UPS On” on page 35.