Ericsson BS120 - Manual (Page 55)

Reference
55
Not
fo
r C
om
me
rc
ia
l Use
Er
icsso
n
Mo
bi
le
C
omm
un
ic
ations
AB
I can not switch on the cordless phone by
pressing On for at least two seconds. Why?
Put the cordless phone in the home base station. If
the display comes on the batteries are almost
discharged. Leave the cordless phone in the home base
station for at least 30 minutes so that the batteries are
charged. If the display remains off after charging the
cordless phone is defective or the batteries may need
replacing. See “Batteries” under “Quick start”.
I have placed the cordless phone in the home
base station but the green charging light does
not come on. Why?
Check if the cordless phone placed properly in the
home base station. If the batteries are completely flat,
leave the cordless phone in the home base station to
charge the batteries, the green charging light will be
lit after approximately 30 minutes.
I know that someone is calling me, but the ring
signal is not ringing. Why not?
If you can see the ring off icon displayed it means that
the volume of the ring signal has been set to zero, or
the ring signal was switched off. If the ring signal has
been switched off, it will revert to on when you hang
up. Press the Up or Down key to increase the volume
of the signal. See “Silencing the ringer” and
“Adjusting the ring volume” under “Settings”.
I can’t call certain numbers. Why not?
The lock icon is flashing quickly on the display. Call
barring is on. See “Call barring” under “Settings”.
The external line light on the home base station
is flashing. Why?
There is a problem with the connection between the
home base station and the telephone line. Check the
telephone cable. See “Installing the set” under “Quick
start”.