Encore electronic ENNUS1 - Manual (Page 12)

4.5 Using the ENNUS1 Server
A. In the Control Center, click the ENNUS1 server that has the desired USB device
attached.
B. Click the desired USB device.
C. Click the “Connect” button. Then the message “Manually Connect by
your_computer_name” will appear.
D. Now, the PC will detect the newly connected USB device. The “connect” operation
is a software operation that simulates an actual USB device plug-in. That is to say,
when you do a “connect” operation in the Control Center, the PC will assume a
USB device is newly connected, although actually you do not physically plug in
any USB device.
E. Use the USB device as if it is connected directly to your PC’s USB port.
F. After you finish using the USB device, click the USB device in the Control Center
and then click the “Disconnect” button to disconnect the USB device. Other PCs
cannot “Connect” the USB device until you “Disconnect” that USB device. That is
to say, no two PCs are allowed to connect the same USB device at the same time.
11