Encore electronic ENNUS1 - Manual (Page 5)

Chapter3 Basic Installation
3.1 Connecting the Hardware
1. Make sure that your USB devices are switched off and that the ENNUS1
Server’s power adapter is disconnected.
2. Connect the USB devices to the USB ports.
3. Connect the ENNUS1 Server to the network with a twisted-pair category 5
cable, 10baseT or 100baseTX.
4. Turn on the USB devices and make sure they are ready for use.
5. Connect the power adapter to the ENNUS1 Server. The power indicator will
light up and the USB indicator will flash. When the Link indicator lights up, the
ENNUS1 Server is correctly connected to the network. The USB indicator stops
flashing when the ENNUS1 Server begins its normal operation.
Please note that if you only connect USB devices to the ENNUS1 server and
do not plug in any LAN cable, the USB LED will not turn on until the LAN cable
is plugged in.
3.2 Assigning an IP Address to the ENNUS1 Server
3.2.1 Preliminary
„
If you have a DHCP server on your network, your ENNUS1 Server will receive
an IP address automatically. The IP address will then appear in the Control
Center or on the web page of configuration. If your DHCP server does not give
an IP address to the ENNUS1 Server, the ENNUS1 Server will use the Factory
IP address: 192.168.1.100.
„
If you are not working in a DHCP network, you need to manually set the
ENNUS1 Server’s IP address.
3.2.2 IP Address
Unless you are assigning an IP address using DHCP, you must obtain an unused IP
address from your network administrator.
3.2.3 Methods for Setting the IP Address
You can set the IP address of your ENNUS1 Server using one of the following methods,
depending on your network operating environment:
„
Automatic IP Address Assignment
„
Manual IP Address Assignment
4