Encore electronic ENNUS1 - Manual (Page 29)

Chapter9 Upgrade Firmware
This chapter describes how to upgrade firmware. Please follow one of the following
methods:
Method A: Using the ENNUS1 Server’s Web Pages
Please refer to section 6.2.2 for details.
Method B: Using the Init Button and the TFTP Client
1. Plug in the power adaptor while pressing the Init button until the USB LED
blinks. Please note that after this step, the ENNUS1 Server will operate
using the factory default values, i.e., your ENNUS1 Server’s
configuration will revert to factory default values.
2. Run the TFTP client Tool: Image Burner, from Windows Start menu.
3. Click Open Image to open your new firmware. Please note that you must
configure your PC’s TCP/IP such that PC and the ENNUS1 Server belong to the
same LAN, e.g. PC’s IP is 192.168.1.xxx and subnet mask is 255.255.255.0.
4. Click Upload Image.
5. Wait for Image Uploading to finish and then click Close.
6. Unplug the power adapter and then plug in the power adapter to restart the
ENNUS1 Server.
28