Encore electronic ENNUS1 - Manual (Page 30)

Chapter10 The Init Button
The Init button is used for maintenance: Simultaneously press Init button and turn
on (by plugging in the power adaptor) the ENNUS1 Server until the USB LED blinks.
The ENNUS1 Server will now do the following tasks:
A. Perform a factory reset of the ENNUS1 server, which restores most of the
parameters and settings to factory default values.
B. Perform a TFTP server. You can upgrade new firmware using any TFTP client tool.
Note: After performing the tasks mentioned above, you have to unplug the power
adaptor and then plug in the power adaptor to restart the ENNUS1 Server.
Version 1.0
Copyright © 2008 Encore Electronics, Inc.
29