Casio STC-PC10 - Manual (Page 54)

52
Error Message Required Action
Cannot open this fi le.
The fi le is damaged or in
the wrong fi le format. The fi les cannot be used for some reason. Select
a different fi le.
Cannot save stamp
data. Insuffi cient free
space to write the data.
Increase the available
space and then save
the data. There’s not enough storage capacity available
on your computer’s hard disk. Delete fi les you
no longer need from your computer’s hard disk
or take other steps to increase the amount of
available storage capacity.
Returns to home.
Proceed? This message appears when you click the
pomrie STAMP MAKER logo while working on a
stamp. To return to the home screen, click OK.
Trimming failed. Try
again. The boundary around the portion of the image
being trimmed is not a continuous unbroken
line. Re-draw the boundary line, make sure it is
continuous and unbroken.
Image conversion failed.
Try again. The image could not be converted correctly. Try
again.
Error Messages
Error Message Required Action
Printing timed out. Try
again. The sheet holder was not inserted into the inlet
slot within the required time. Perform the print
operation again.
Printer not found. Check to make sure that Printer power is turned
on.
Printing failed.
A printer error occurred. The stamp face could not be encoded
(converted) correctly. Try again.
Printing failed.
Return the release lever
to its original position. Check to make sure that the release lever in not
in the released position.
Printing failed.
Check the sheet holder. This can be due to any of the causes below.
The inserted sheet holder size is different from
stamp face size.
The orientation (front-back, top-bottom) of the
inserted sheet holder is not correct.
The sheet holder was not inserted far enough
to engage the transport mechanism.
Trying to insert a sheet holder before creating a
stamp sheet.
Use the following steps to correct the problem.
1. Pull out the sheet holder.
If the sheet holder is jammed, shift the
release lever on the bottom of the Printer
to the RELEASE side and then pull out
the sheet holder. After removing the sheet
holder, return the release lever to the PRINT
side.
2. Referring to "Printing a stamp" (page 17 ),
create the stamp sheet again.
•
•
•
•
•