Eicon Networks V8.3 - Manual (Page 23)

Software Installation 23
Installing fully detected Diva Server adapters under Windows
Server 2003
1. After you have installed your Diva Server adapter as described in the printed
installation guide that came with your adapter or that you downloaded from the Eicon
Web site, start your computer.
Note: You must log on with administrator rights to install Diva Server for Windows.
2. Windows detects the Diva Server adapter.
3. The ‘Found New Hardware Wizard’ is displayed. Click ‘Finish’ to complete the process.
The standard Windows Server 2003 drivers for your Diva Server adapter are installed. To
be able to use all features of Diva Server for Windows, you must update the drivers with
the software that is provided on your Diva Server Software Suite CD-ROM or that you
downloaded from the Eicon Networks Web site. To update the drivers, follow the
instructions below.
Note: Assign the MSNs, extension range, phone numbers, or SPIDs later on in the Diva
Server Configuration Manager after you installed the Diva Server for Windows software.
To update the drivers:
Note: If multiple adapters are installed, the wizard will be visible only once for each update
or configuration of the software. The configured parameters correspond to all adapters.
1. From the Windows task bar, click ‘Start > Run’.
2. Type the path to the update file:
• Insert your Diva Server CD-ROM into the CD-ROM drive and enter the following
path:
D:\DRIVER\i386\ENGLISH\SETUP.EXE
(where D: is your CD-ROM drive letter)
• Or enter the path to the update file on the hard disk, e.g.
C:\Temp\ISDN
(where C: is the hard disk drive letter)
3. In the welcome dialog box, click ‘Next’ to start updating the drivers for all installed Diva
Server adapters.
4. If you installed an adapter that is not supported with this software version, the
‘Unsupported Adapter’ box appears. Download the drivers for the unsupported
adapters and continue with the installation of the supported adapters. For supported
adapters see
Supported Hardware on page 14. This software version only supports
the adapters listed there.